 My DIYPNP install! |
 Oct 10, 2012 - 2:11 PM
|
 
|
 Enthusiast  Joined Aug 31, '02 From Philadelphia, PA Currently Offline Reputation: 8 (100%)  |
I finally found some time to assemble my DIYPNP kit today. :thumbup
The assembly process wasn't too bad. Everything was clearly labeled and the instructions were easy to follow. But if youre reading this and you bought an MSPNP, consider yourself lucky as soldering lots of very tiny components too up most of the day (and I'm still not done!). I started out with this:  And after a few hours here is where I'm at!  This is the kit I'm using. http://www.diyautotune.com/catalog/diypnp-...-kit-p-384.html Along with the sequential injection mod. http://www.diyautotune.com/catalog/diypnp-...-kit-p-386.html -------------------- 15PSI - 30MPG - Megasquirt Tuned
|
 |
Replies
|
Oct 12, 2012 - 6:23 PM
|
|
 Enthusiast Joined Feb 11, '08 From Auckland, New Zealand Currently Offline Reputation: 0 (0%) |
So is the base map good to drive on after an AFR auto tune?
would i have any need to change ignition system components? i have gen3 3s-gte -------------------- Mike W
1996 Toyota Celica ST205 GT-FOUR GT2860RS turbine, TiAL mvr44, JE 86.5φ piston, Clutchmasters FX400, APEX P-FC 269awhp / 273ft-lbs |
Posts in this topic
lagos My DIYPNP install! Oct 10, 2012 - 2:11 PM
Smaay what is it going to be running? Oct 10, 2012 - 2:57 PM lagos QUOTE (Smaay @ Oct 10, 2012 - 3:57 P... Oct 10, 2012 - 3:04 PM Syaoran I love MS.
Did you get the JimStim? Oct 11, 2012 - 2:07 PM lagos QUOTE (Syaoran @ Oct 11, 2012 - 3:07... Oct 11, 2012 - 2:42 PM
Syaoran QUOTE (lagos @ Oct 11, 2012 - 3:42 P... Oct 11, 2012 - 6:58 PM Batman722 Art, you are one crazy mother trucker. Oct 11, 2012 - 8:47 PM lagos QUOTE (Syaoran @ Oct 11, 2012 - 7:58... Oct 12, 2012 - 1:05 AM Syaoran QUOTE (lagos @ Oct 12, 2012 - 2:05 A... Oct 12, 2012 - 1:52 AM delusionz i havent seen any threads in regards to tuning, si... Oct 12, 2012 - 5:57 AM Syaoran QUOTE (delusionz @ Oct 12, 2012 - 6... Oct 12, 2012 - 3:31 PM jcbass7 Art, I am stoked to see this thread come up. I wi... Oct 12, 2012 - 10:25 AM lagos QUOTE (delusionz @ Oct 12, 2012 - 6... Oct 12, 2012 - 11:39 AM lagos QUOTE If you don't have a serial port in your ... Oct 12, 2012 - 7:05 PM Syaoran QUOTE (delusionz @ Oct 12, 2012 - 7... Oct 12, 2012 - 8:48 PM rave2n QUOTE (Syaoran @ Oct 12, 2012 - 8:48... Oct 16, 2012 - 7:22 AM lagos QUOTE (Syaoran @ Oct 12, 2012 - 9:48... Oct 12, 2012 - 8:59 PM Syaoran I'm assuming you followed this? http://www.diy... Oct 12, 2012 - 9:41 PM soulshadow You have to set the correct com port and you have ... Oct 13, 2012 - 11:07 PM soulshadow Baud Rate = 115200
Data Bits = 8
Parity = None
st... Oct 13, 2012 - 11:14 PM Matt_Cramer The settings sound OK. At this point, it looks lik... Oct 15, 2012 - 2:20 PM ricochet1490 This topic sparks my interest. Oct 15, 2012 - 5:59 PM lagos QUOTE (Matt_Cramer @ Oct 15, 2012 - 3... Oct 15, 2012 - 8:28 PM soulshadow You did Jumper the board for programming........r... Oct 16, 2012 - 12:36 AM lagos QUOTE (soulshadow @ Oct 16, 2012 - 1... Oct 16, 2012 - 1:00 AM soulshadow I take it that your board is getting 12V+ from you... Oct 16, 2012 - 11:38 PM lagos QUOTE (soulshadow @ Oct 17, 2012 - 12... Oct 17, 2012 - 12:14 AM soulshadow Good Luck! Oct 17, 2012 - 3:53 AM playr158 :bump: What happened to this!
hopefully its ... Jan 2, 2013 - 9:26 AM lagos I had trouble loading the firmware as stated above... Jan 2, 2013 - 10:29 PM WannabeGT4 Any updates? Apr 16, 2013 - 11:03 AM Syaoran Are you using the stock distributor's sensor f... Apr 16, 2013 - 5:49 PM lagos QUOTE (Syaoran @ Apr 16, 2013 - 6:49... Apr 16, 2013 - 8:30 PM Syaoran Yes, I'm using MS2. We tapped it directly at t... Apr 16, 2013 - 8:55 PM Syaoran I also forgot to mention you'd need 2 BIP373 i... Apr 16, 2013 - 9:03 PM lagos QUOTE (Syaoran @ Apr 16, 2013 - 9:55... Apr 16, 2013 - 9:36 PM WannabeGT4 QUOTE (lagos @ Apr 16, 2013 - 9:36 P... Apr 16, 2013 - 11:00 PM Syaoran I forgot your DIYPNP is for the 3SGTE, right? Apr 16, 2013 - 9:45 PM lagos QUOTE (Syaoran @ Apr 16, 2013 - 10:4... Apr 16, 2013 - 11:52 PM Syaoran QUOTE (lagos @ Apr 17, 2013 - 12:52 ... Apr 17, 2013 - 12:19 AM WannabeGT4 QUOTE (lagos @ Apr 16, 2013 - 11:52 ... Apr 17, 2013 - 9:59 PM lagos QUOTE (WannabeGT4 @ Apr 17, 2013 - 10... Apr 17, 2013 - 10:08 PM lagos Small update on the project.
https://www.youtub... May 14, 2013 - 7:34 PM WannabeGT4 Nice. Dyno run soon? May 14, 2013 - 7:37 PM lagos More like street tune, soon. May 14, 2013 - 8:56 PM Special_Edy There may be some useful info about the distributo... May 15, 2013 - 6:39 AM lagos QUOTE (Special_Edy @ May 15, 2013 - 7... May 15, 2013 - 10:59 AM WannabeGT4 QUOTE (lagos @ May 15, 2013 - 10:59 ... May 15, 2013 - 11:06 AM presure2 QUOTE (lagos @ May 15, 2013 - 11:59 ... May 16, 2013 - 4:57 PM jcbass7 QUOTE (lagos @ May 15, 2013 - 10:59 ... May 16, 2013 - 7:33 PM playr158 Nice work Art! May 15, 2013 - 1:46 PM lagos QUOTE (jcbass7 @ May 16, 2013 - 8:33... May 17, 2013 - 6:58 PM |
6 User(s) are reading this topic (6 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: November 23rd, 2024 - 3:11 PM |