 Not cranking & Code 12. |
 Nov 14, 2012 - 10:19 PM
|
 
|
 Enthusiast  Joined May 29, '12 From NC Currently Offline Reputation: 0 (0%)  |
94 ST 5spd.
I'm having a issue car won't crank, so far i have check power/grounds, fuses, clutch safety switch all were good. I notice the fuel pump will only prime if you're trying to start the car (Key turned all the way), other than that i can roll start it and it pure like a kitten and pulled the codes and got 12 (Which i can't find codes anywhere), but car has no light on while it's running. This is my dd and i need it up and going soon, until then i hate to but will roll start it when needed. --------------------  Cleaning and improving my new found yoter little by little. |
 |
Replies
|
Nov 15, 2012 - 10:00 AM
|
|
 Enthusiast Joined Feb 5, '05 From pineapple under the sea Currently Offline Reputation: 9 (100%) |
QUOTE other than that i can roll start it and it pure like a kitten and pulled the codes and got 12 (Which i can't find codes anywhere), but car has no light on while it's running. Did you check the internets? A 5 second google search told me most of Toyota's OBDI codes. QUOTE Here are the common codes for Toyota vehicles 1988-95: Code 11 Momentary interruption in power supply to ECU (electronic control unit or computer) up to 1991 Code 12 Engine revolution signal missing Code 13 Rpm signal to ecu missing above 1000 rpm Code 14 Igniter signal to ecu missing Code 16 A/T control signal missing from ecu Code 21 Main oxygen sensor signal fault Code 22 Water temperature sensor circuit fault Code 23 and 24 Intake air temperature signal fault Code 25 Air/fuel ratio LEAN Code 26 Air/fuel ratio RICH Code 27 Sub-oxygen sensor signal or heater circuit fault Code 28 No.2 oxygen sensor/heater signal fault Code 31 and 32 Air flow meter circuit or Vacuum sensor signal fault Code 34 and 36 Turbo-charging pressure signal fault Code 35 Altitude compensation sensor signal fault Code 41 Throttle position circuit fault Code 42 Vehicle speed sensor circuit Code 43 No starter signal to the ecu Code 51 AC signal on; DL contact off (in trany shifter with diagnostic connector jumped) Code 52, 53 and 55 Knock sensor fault Code 71 EGR system malfunction Code 72 Fuel cut solenoid signal fault Code 78 Fuel pump control signal fault Code 81, 83, 84 and 85 TCM communication fault Check the connections at the distributor to make sure you have them all plugged in. Otherwise you should just go buy a remanufactured distributor assembly and replace yours. Problem solved. -------------------- 1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of money
 I'm not really an asshole, but I play one on the internet. **** Photobucket |
Posts in this topic
Takumi-FujiWaraST Not cranking & Code 12. Nov 14, 2012 - 10:19 PM
Special_Edy QUOTE (Takumi-FujiWaraST @ Nov 14, 2012 ... Nov 15, 2012 - 1:30 AM seanb Like was said, check the distributor and the coil.... Nov 15, 2012 - 9:24 AM Special_Edy It sounds like he is having starter issues instead... Nov 15, 2012 - 10:21 AM 95CelicaST Could be. The ECU checks for this signal from the ... Nov 15, 2012 - 11:12 AM
Special_Edy QUOTE (95CelicaST @ Nov 15, 2012 - 11... Nov 15, 2012 - 2:46 PM Smaay its cranking just not starting. when you say its n... Nov 15, 2012 - 4:11 PM Takumi-FujiWaraST No when i say it's not cranking i mean it... Nov 15, 2012 - 6:13 PM Smaay have you checked the clutch start switch? sounds l... Nov 15, 2012 - 6:42 PM Takumi-FujiWaraST Found and fixed, it was the saftey start sensor on... Nov 22, 2012 - 9:04 AM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: February 22nd, 2025 - 3:16 PM |