6G Celicas Forums

Welcome Guest ( Log In | Register )

> Not cranking & Code 12.
post Nov 14, 2012 - 10:19 PM
+Quote Post
Takumi-FujiWaraS...



Enthusiast
*
Joined May 29, '12
From NC
Currently Offline

Reputation: 0 (0%)




94 ST 5spd.

I'm having a issue car won't crank, so far i have check power/grounds, fuses, clutch safety switch all were good. I notice the fuel pump will only prime if you're trying to start the car (Key turned all the way), other than that i can roll start it and it pure like a kitten and pulled the codes and got 12 (Which i can't find codes anywhere), but car has no light on while it's running.

This is my dd and i need it up and going soon, until then i hate to but will roll start it when needed.


--------------------

Cleaning and improving my new found yoter little by little.
 
Start new topic
Replies
post Nov 15, 2012 - 11:12 AM
+Quote Post
95CelicaST



Enthusiast
*****
Joined Feb 5, '05
From pineapple under the sea
Currently Offline

Reputation: 9 (100%)




Could be. The ECU checks for this signal from the ignitor when the ignition switch is in the start position. If the starter doesn't turn because there is a problem with the starting system, the ECU won't receive the RPM signal and can throw code 12.

Never had a bad starter throw a code on my old ST... and I went through two of them.


--------------------
1991 MR2 - T-tops - Crimson Red - Gen3 3SGTE - Lots of money

I'm not really an asshole, but I play one on the internet.
**** Photobucket

Posts in this topic


Reply to this topicStart new topic
5 User(s) are reading this topic (5 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: February 22nd, 2025 - 3:37 PM