Strut bar fabrication gone wrong, Need advice Options

[UVZ164]

So made a strut bar today all fits perfectly, is beefy as all hell but then I decide to try and shut the bonnet.....
When I was measuring it, I didnt notice the support bars running along the underside of the bonnet and of course with my luck they hit the strut bar preventing me from closing the bonnet

So now I need some ideas from you guys on how to modify the strut bar without starting again.

My favourite idea is cutting the bar in the middle and bashing the bends at either end down a little but and then re-welding it in the middle. My concern is strength when it is re-welded.
OR
I can grind off the welds at each end and make the bends a slightly lesser angle. Prefer not to do this one but if its the best option I guess I have no choice.

If theres any other ideas you guys/gals can think of let me know or please critique mine just above.
It is going to become a 3-pt bar just trying to sort two out first.

Here are the pics:

[Tigawoods]

Add spacers to the bolts that attatch your hood. You can only put on so many before the bolt doesn't have enough threads to grab. I may have a couple pics of my setup in my build thread, but your be able to get a better idea of how it looks by googling hood spacing