![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Aug 25, '08 From England Currently Offline Reputation: 1 (100%) ![]() |
I was certain I started a build thread on here, but for the life of me I can not find it so forgive me if I start again and its old news.
About a year and a half ago my current GT4 failed its yearly inspection (MOT) with rusty sills, they were fixed and it subsequently passed but it set alarm bells ringing in my head that the poor things days were numbered. I decided that I would buy a shell and swap everything onto it. so I hunted for a reasonable shell to start work on. While I was looking, I had to extend my garage. I only had a single car garage so not enough space to work or store stuff. So I decided to extend my garage backwards a bit Work started. ![]() and after a few weeks, finished ;0 ![]() ![]() About the same time a shell turned up, well it was sold as a shell, but it was more or less a complete car minus the engine and gearbox. ![]() ![]() ![]() It was in good condition with no rust, even the interior was in pretty much spot on condition, not that I need much of it ![]() ![]() I set to wrok more or less straight away ![]() First job was to strip everything off the car ![]() everything went, all the looms, glass, suspension the works ![]() Next job was to remove the sound deadening material ![]() ![]() it then went outside for a thorough jet wash go get rid of all the years of crap ![]() ![]() As I was moving the battery to the inside I could remove the battery tray ![]() which I did ![]() ![]() Next up I needed to get to the bottom of the car....this was going to require some ingenuity. -------------------- |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Aug 25, '08 From England Currently Offline Reputation: 1 (100%) ![]() |
Taking a long look at my roll cage, I was not happy with the welds. so i decided to dress them, smooth them out, add a little body filler and make them smooth
![]() started looking much better although I did have to remove the main hoop cross member for access ![]() dont worry its not going to be that colour, thats just filler primer ![]() at the same time I cleaned up the floor and primed that ready for paint ![]() the boot aswell....I also welded the cross member back in ![]() ![]() Next up was the seam sealer, so I masked off the areas I was going to apply it to ![]() then applied the U-Pol grey stripe seam sealer (nasty stuff) ![]() ![]() and that is about where I am up to today. Just been out into the garage to remove the masking tape. it looks a bit messy, but when its primed over the top you can hardly tell its there. I will add more pictures when I have taken them. I will update when I get a chance but I work pretty slowly so dont expect much. hope I havnt bored you to death more to come Nial -------------------- |
![]() ![]() |
Lo-Fi Version | Time is now: August 18th, 2024 - 9:12 PM |