AT vs ST chassis differences? Options

[Nespeed]

Just looking for info on the major to minor differences between a AT and ST chassis.

[Nespeed]

Thanks for all the info, this will save me a lot of time. I had looked over the car and notice ill have to find a different gas tank or run a cell, and fab up mounts for the carrier bearing for the drive shaft. If I have a rear AWD subframe that should bolt up, correct? So next step is to find me a GT4 clip!

[GMan]

Thanks for all the info, this will save me a lot of time. I had looked over the car and notice ill have to find a different gas tank or run a cell, and fab up mounts for the carrier bearing for the drive shaft. If I have a rear AWD subframe that should bolt up, correct? So next step is to find me a GT4 clip!

The ST205 rear floor pan is unique to the GT4. The GT4 sub frame will not bolt up directly to other models.
Need to fab up mounts. I can and has been done. Not hard if you are good at welding. :-)
Gas tank for an ST205 or an ST185 could be used, just hangs a bit low.

Have you done a search for ST205 or AWD swaps ?
There were two in the MA area.

Regards;
------------------------


This post has been edited by GMan: Jan 7, 2013 - 9:07 PM