Test fit of my custom lamps. Halo Projectors, Finished on Page 4 Options

[yellowchinaman]

Use a little imagination here


today I marked up how much I need to trim off the fender bottom edge and also the tubular part of the lamp on the bumper.
The idea is I wont need the middle lamps so I can have 1 as a air intake and the other to be flushed out.
The fitting of these lamps will be more aerodynamic than the stock ones and best of all, these are clear lense and have projector halos in them B)

This post has been edited by yellowchinaman: Jan 6, 2014 - 3:11 PM

[yellowchinaman]

Thanks bud. So when would you like for me to do yours then?

Anyway regarding my head light, I never got round to posting pictures.
So here it is:
This is all the pieces which forms the lamp layed out.

Here are the bulbs fixed in which retains the full adjusting rods meaning I can angle them when on the car

Access to bulbs and wires are easy

Halo's with the reflective backing

Halo wires are sealed using these bungs making it water tight

I heated the old glue and taped the clear covers in till it set.

Then for extra insulation I used PU glue all the way round making it air tight

The same glue was also used around the lense cover so I can glue the rubbers on

Tape and set in place

Finished




Now I just need to get hold of the wiring looms for the 4 lamps and wire in the plugs to this