 Wiring subs? |
 Nov 29, 2004 - 12:43 AM
|
 
|
 Enthusiast  Joined Jul 16, '04 From Los Angeles Currently Offline Reputation: 8 (100%)  |
Ill be running two of these http://www.cardomain.com/item/KIC03C104
OK after a small bit of research i have found that i should use a 2 ohm mono amp and wire the two 4ohm subs in parallel. NOW my question is What should the amp put out to the speakers? Should it be the RMS of both amps or jsut the RMS of one amp. ex. if the rms is 100w then should the amp put out an rms of 100w or 200w because im running two. Im also looking to not spend a lot. Could i jsut run a 2 chan amp and each of the two subs off of one of the two chanels. Or would that not get me good sound. This post has been edited by urbandork: Nov 29, 2004 - 1:08 AM |
Posts in this topic
urbandork Wiring subs? Nov 29, 2004 - 12:43 AM
Scarrell you want an amp to match the subs rms, get the JBL... Nov 29, 2004 - 1:43 AM urbandork but isnt that like 300w the sub rms is only 125w ?... Nov 29, 2004 - 1:39 PM Scarrell no, the subs handle 125rms, you want to send them ... Nov 29, 2004 - 3:29 PM urbandork just so i know can you give me a run down on the w... Nov 29, 2004 - 4:15 PM
Digndoug you best be, if your running two subs, get a 2 cha... Nov 29, 2004 - 4:34 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: January 10th, 2025 - 11:40 PM |