6G Celicas Forums

Welcome Guest ( Log In | Register )

> DIY: install factory cruise control in a non cruise equiped car, everything u need to know! lots of pics
post Jul 12, 2009 - 7:10 PM
+Quote Post
Ryouxrs



Enthusiast
**
Joined Mar 26, '09
From Longmont, CO.
Currently Offline

Reputation: 0 (0%)




well i finally got it done, what is needed for this project are these parts. cruise contol actuator(under hood, and behind gas pedal) wiring harness, brake pedal switch, cruise control computer (CCM), cruise control steering wheel switch and switch cover, SRS clock ring (located behind steering wheel), combination meter with cruise light bulb ( or make your own like i did) well thats all the parts, its not a very expensive job, i maybe spent 75 dollars total on this swap. but it is VERY time consuming. lots of fun stuff to wire in, well here goes nothing... first off install all the little bits and pieces of the system, dnt worry about the wiring just yet. get all the hard part mounted up. once thats all done the fun begins, start by removing the lower drivers dash, glove box, center consoule, water fall trim, and the instrument cluster. (remove the steering wheel if you havnt already installed your new clock ring and cruise switch. the removal and instalation is pretty straight forweard for those parts. all u will need is a short and standard length philips screw driver, and a 10 & 12 mm socket and ratchet. first part of the wiring is the actuator in the engine bay, the wires run under the rad. support to the drivers side inner fender, then into the grommet on the firewall inside the drivers fender, the next step is to drill the mounting holes for the gas pedal actuator, using a 9/32 drill bit, dril the 2 mounting holes in the center of the tar paper punch outs. MAKE SURE TO DRILL SHALLOW!!! one of the mounting holes goes right behind your brake proportioning valve. then using the origional bolts, mount the actuator. then your off to that crazy looking wiring harness. all of the wiring notes, and locations are listed in the pictures below, as well as the toyota diagram for the cruise system. enjoy, and happy cruisin!

sry for the stupidly small print, download the image and blow it up to see writen txt














































PDF file from toyota service manual: please e-mail me with a request for this file, and i will reply back with the requested information.

This post has been edited by Ryouxrs: Jul 12, 2009 - 7:15 PM


--------------------
Lift Addict!! ^_^
----------------------

Posts in this topic
- Ryouxrs   DIY: install factory cruise control in a non cruise equiped car   Jul 12, 2009 - 7:10 PM
- - njccmd2002   wow, dude if this works, props to you. it really ...   Jul 12, 2009 - 10:07 PM
|- - Ryouxrs   QUOTE (njccmd2002 @ Jul 12, 2009 - 9...   Jul 12, 2009 - 11:53 PM
- - njccmd2002   just out of curiosity. what was the total cost. 7...   Jul 13, 2009 - 6:24 AM
|- - Ryouxrs   QUOTE (njccmd2002 @ Jul 13, 2009 - 5...   Jul 13, 2009 - 10:47 AM
- - Ruroniarc   I really want to do this to my car. Could you give...   Jul 13, 2009 - 2:24 PM
- - Ryouxrs   ok, send me an e-mail to my hotmail, and ill send ...   Jul 13, 2009 - 2:30 PM
- - Ruroniarc   Hey, do you know if it matters whether or not the ...   Aug 11, 2009 - 5:02 PM
- - Ryouxrs   yes, the cruse sytems are the same for manual or a...   Aug 11, 2009 - 9:48 PM
- - eduardorq   wooooooOWWWW..!!! very nice mod inform...   Sep 7, 2009 - 1:16 PM
- - DEATH   Fcuk - guess I need to get around to doing this wi...   Sep 11, 2009 - 9:52 AM
- - Ryouxrs   thanks death, and ya, its pretty much the same for...   Oct 18, 2009 - 1:49 PM
- - Makabra   I want to know if i buy cc from RHD car, will it f...   Sep 21, 2010 - 2:27 AM
- - Makabra   Anyone?   Oct 3, 2010 - 9:46 AM
- - Ryouxrs   you would have to extend the wiring for the lhd/rh...   Oct 3, 2010 - 12:50 PM
- - Makabra   Thanks for the tip !:) Maybe You have any ph...   Oct 3, 2010 - 1:28 PM
- - Ryouxrs   unfort i dnt dnt have one to dig into and find al...   Oct 6, 2010 - 7:00 PM
- - Ryouxrs   Ok everyone ive got an update, ive made it work wi...   May 18, 2013 - 12:55 PM
|- - Makabra   QUOTE (Ryouxrs @ May 18, 2013 - 12:5...   Oct 21, 2013 - 3:54 AM
- - Ryouxrs   Yes, I am useing the 7a setup on my 3s as the syst...   Oct 21, 2013 - 6:49 AM
- - bsamps4   Great work! This should be stickied!   Oct 21, 2013 - 8:19 AM
- - Makabra   Question: Which type of clutch sensor do I need? C...   Oct 27, 2013 - 11:51 AM
- - Ryouxrs   Yes. You are correct. The upper stopper in your la...   Oct 27, 2013 - 12:30 PM
- - Ryouxrs   ok here is the diagrams, and a few operation descr...   Oct 27, 2013 - 1:21 PM
- - Makabra   Thanks very much Ryouxrs I will post my progress ...   Oct 27, 2013 - 1:56 PM
- - Makabra   If a donnor car wit CC has ABS with broken sensor,...   Oct 31, 2013 - 2:52 AM
- - Ryouxrs   No the abs doesn't affect the cruise control i...   Oct 31, 2013 - 10:06 PM
- - Makabra   Could i replace clutch switch with old 2pin brake ...   Nov 2, 2013 - 7:38 PM
- - Ryouxrs   I'm not sure how it acts compared to the brake...   Nov 3, 2013 - 11:43 PM
- - Makabra   QUOTE I'm not running one at the moment becaus...   Nov 4, 2013 - 2:10 AM
- - Ryouxrs   It will but I don't recommend it because if yo...   Nov 4, 2013 - 6:14 PM
- - Makabra   Yes i just want to bypass clutch sensor only once ...   Nov 5, 2013 - 2:31 AM
- - msk59   I am gathering parts to do this mod on my 1996 ST....   Aug 29, 2014 - 8:17 AM
- - Ryouxrs   This is not a plug and play mod unless you take th...   Aug 29, 2014 - 9:08 AM
- - msk59   Thank You Ryouxrs. I have the actuator from the ST...   Aug 29, 2014 - 10:35 PM
- - Ryouxrs   If you have any questions I'll be glad to answ...   Aug 29, 2014 - 10:50 PM
- - msk59   Much Appreciated Ryouxrs. The connector next to th...   Aug 30, 2014 - 12:50 PM
- - Ryouxrs   That connector goes from the cruise actuator to th...   Aug 31, 2014 - 12:19 AM
- - msk59   Got it thanks. I will double check this location. ...   Aug 31, 2014 - 3:51 PM
- - Ryouxrs   Unfortunately when it comes too the fog light wiri...   Aug 31, 2014 - 7:33 PM
- - msk59   Hey thanks, I will try to do that but I am facing ...   Aug 31, 2014 - 8:36 PM
- - Ryouxrs   Ok. I have a 94 so it didn't have any of the f...   Aug 31, 2014 - 10:22 PM
- - njccmd2002   please see under the glove box, if you have the pl...   Sep 1, 2014 - 2:00 AM
- - msk59   Thanks Ryouxrs as always I will keep you posted. ...   Sep 1, 2014 - 7:59 AM
- - Ryouxrs   The pigtail njccmd2002 is talking about should be ...   Sep 1, 2014 - 10:10 AM
- - msk59   OK I just looked through behind the glove box and ...   Sep 1, 2014 - 6:34 PM
- - njccmd2002   best pic to have from my archive. circled is th...   Sep 1, 2014 - 9:31 PM
- - msk59   OK this picture will help. I don't think I hav...   Sep 1, 2014 - 9:53 PM
- - njccmd2002   its part of the main dash wires.   Sep 1, 2014 - 11:10 PM
- - Ryouxrs   Looks like all the pictures you've taken are o...   Sep 2, 2014 - 6:47 AM
- - msk59   Yes, After seeing the picture njccmd2002 psoted, I...   Sep 2, 2014 - 8:45 AM
- - msk59   OK checked everything on the right hand side. It i...   Sep 2, 2014 - 5:41 PM
- - njccmd2002   quick question, if the clutch sensor is only used ...   Oct 6, 2014 - 11:46 PM
- - enderswift   there are two switches for the clutch pedal. One s...   Oct 6, 2014 - 11:59 PM
- - njccmd2002   Hmmm.. Ill go back and see tomorrow....   Oct 7, 2014 - 12:05 AM
- - msk59   OK waiting on the parts and wiring pigtail from a ...   Oct 8, 2014 - 9:46 PM
- - njccmd2002   Anyone have an idea what this means.... Cant fi...   Oct 12, 2014 - 10:14 PM
- - msk59   check the electrical manual and on page 9 it shows...   Oct 13, 2014 - 3:36 PM
- - njccmd2002   i figured it out, its only for automatic, and it d...   Oct 20, 2014 - 3:05 PM
- - Ryouxrs   Sorry I havnt been replying guys! I'll be ...   Oct 20, 2014 - 8:06 PM
- - njccmd2002   he should have the DIY Kit!!!!   Oct 20, 2014 - 11:01 PM
- - Ryouxrs   DIY kit??   Oct 20, 2014 - 11:26 PM
- - njccmd2002   he has all my cruise components.. I removed it en...   Oct 23, 2014 - 7:36 AM
- - Ryouxrs   Nice!! I was actually thinking about build...   Oct 23, 2014 - 1:05 PM
- - Makabra   Lol, its been almost 2 years now and I just finaly...   Aug 2, 2015 - 1:19 PM
- - Ryouxrs   I am still trolling the forums. Lol. I'll try...   Aug 2, 2015 - 5:36 PM


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: November 28th, 2024 - 12:57 PM