Emanage Blue settings for 3sfte - help needed :), any 5sfte people able to help at all on emanage settings? Options

[digs]

Hi, know I am a newbie on this board but had a question if anyone can help...

Setting up an emanage blue for my 3sfte.

Rotary settings are 3 (coil packs plus 4 cylinders)/4/2.

Jumper settings were standard.

When I plugged in the emanage with ignition harness, I could not get the engine to start (turned over but would ignite). Without the emanage it starts and runs (though overfuelling!!)

I did look around, and found one Japanese page that said the jumper 2 setting needed to be set to 2/3 not 1/2, as that sets ignition out to 12v not 5v, as the engine used 12v. And without doing that the engine wouldn't start.

So.....I took a risk and did it. And killed all my electrics! Hoping it's a fuse (checking after work today) but has anyone any ideas of the emanage blue settings for a 3sfe?

Or the 5sfe, apart from the distrubuterless ignition the 3sfe has (5sfe has a distributor right?) they should be the same...? The 3sfe comes with MAP normally, not MAF, assume the 5sfe is the same?


Thanks if anyone knows this one!