FS: 95 Celica GT Part Out, needs to be gone buy June 1, 2013 Options

[nics]

line that connects to the master cylinder clutch to the slave....the whole line...93727 or probably pick up

I have to check on how to take that off.

how much would you ask for the passenger side seatbelt assembly?

Will give you an update on that later today.

Original Post updated

[SwissFerdi]

What Mike said, the frame for the rubber is the same, but the gasket piece directly around the cables is unique to the manual. I am going by the assumption that you have the interior apart, so it's not that hard to get to. Underneath the car then are four nuts for the exhaust shield and then three bolts for the other side of the gasket. It took me about ten minutes to remove from another car.

Please, and thank you.

This post has been edited by SwissFerdi: May 14, 2013 - 4:48 PM

[nics]

What Mike said, the frame for the rubber is the same, but the gasket piece directly around the cables is unique to the manual. I am going by the assumption that you have the interior apart, so it's not that hard to get to. Underneath the car then are four nuts for the exhaust shield and then three bolts for the other side of the gasket. It took me about ten minutes to remove from another car.

Please, and thank you.

The dash is mostly intact still. I will try to get that for you then. Thanks

[nics]

Orig post edited

[PaukST]

How much would you like for the passenger side window and lock control panel (assuming it's not already taken, and all the tabs are intact)? A pic of mine so you know what piece I'm talking about.


This post has been edited by PaukST: May 15, 2013 - 1:17 PM

[nics]

How much would you like for the passenger side window and lock control panel (assuming it's not already taken, and all the tabs are intact)? A pic of mine so you know what piece I'm talking about.

PM sent

[1994Celica]

Is the fuel/gas door in good shape?

[jaxtheax]

How much do you want for the trim pieces around the radio and gear shift?

[nics]

Is the fuel/gas door in good shape?

Yes sir, i can take a pic tom.

How much do you want for the trim pieces around the radio and gear shift?

The one around the radio has been sold. The gear shift trim would be $15 + shipping.

[1994Celica]

Is the fuel/gas door in good shape?

Yes sir, i can take a pic tom.

Sounds good. how much do you want with shipping? My zip is 79424.

[nics]

Is the fuel/gas door in good shape?

Yes sir, i can take a pic tom.

Sounds good. how much do you want with shipping? My zip is 79424.

will calculate and get back at you. Thanks

[nics]

Bump! Update on original post

[SwissFerdi]

The dash is mostly intact still. I will try to get that for you then. Thanks

A friendly bump for this.

[nics]

The dash is mostly intact still. I will try to get that for you then. Thanks

A friendly bump for this.

Thanks Ferdi, I had time to take apart the dash. I will look into your gasket!

[PaukST]

Got the window/lock control panel today, it's in great shape! Thanks a bunch!

I'm also interested in a bunch of other pieces, that I didn't think of before...

1) the shifter plastic trim (does it have all/most of the tabs for holding the shift boot?)
2) the short cable that goes from the rear hatch latch mechanism to the rear hatch lock
3) the aim-able passenger side climate control/blower vent closest to the door (if it still has most of the tabs to hold it in place)
4) the driver side mirror
5) the turn signal/headlight switch
6) the windshield sprayer nozzles (assuming they're not clogged)
7) the entire hood latch mechanism (the handle thing under the dash, the cable from there to the latch, the latch mechanism itself, and the loop on the underside of the hood that it hooks onto, and all the bolts/screws to go with it)


I'm also trying to get the inner fender well plastics, but they'd probably be way expensive to ship due to their size. If they won't be super expensive to ship I'd love a price on those as well. I wish I'd gotten to your thread sooner - I'm trying to get myself that rear hatch cover as well, but someone beat me to it

[nics]

Got the window/lock control panel today, it's in great shape! Thanks a bunch!

I'm also interested in a bunch of other pieces, that I didn't think of before...

1) the shifter plastic trim (does it have all/most of the tabs for holding the shift boot?) Yes it still has the tab for the shift boot
2) the short cable that goes from the rear hatch latch mechanism to the rear hatch lock available
3) the aim-able passenger side climate control/blower vent closest to the door (if it still has most of the tabs to hold it in place) one tab is broken, still work, i tried it
4) the driver side mirror available
5) the turn signal/headlight switch available
6) the windshield sprayer nozzles (assuming they're not clogged) maybe clogged, not recommended
7) the entire hood latch mechanism (the handle thing under the dash, the cable from there to the latch, the latch mechanism itself, and the loop on the underside of the hood that it hooks onto, and all the bolts/screws to go with it) available


I'm also trying to get the inner fender well plastics, but they'd probably be way expensive to ship due to their size. If they won't be super expensive to ship I'd love a price on those as well. I wish I'd gotten to your thread sooner - I'm trying to get myself that rear hatch cover as well, but someone beat me to it a lot of people had interest on it

Will PM you tonight on the details. Pleasure doing business with you!

[cheela]

are floor mats still available?

[nics]

are floor mats still available?

Yes, they are the 25th anniversary floor mats

[micronian]

Is the climate control, you posted a picture of, still available?

[nics]

Is the climate control, you posted a picture of, still available?

Yes it is, what is your zip?