6th Gen Build Take Two Options

[dspain7]

Found some time to get back at the project again today and I was able to get the first half of the underside cleaned and painted. I also installed the st205 shifter cables, twosrus aluminum shifter bushings as well as the suspension techniques swaybar and poly bushings.

[BonzaiCelica]

are you afraid of superstrut?? is that why you went mcpherson??

or your installing TRD big brake kit??? or Wilwood????

This post has been edited by BonzaiCelica: Feb 26, 2018 - 9:35 AM

[Durs]

Gran trabajo te va quedar nuevo, usas pintura en spray o es pistola?

[dspain7]

are you afraid of superstrut?? is that why you went mcpherson??

or your installing TRD big brake kit??? or Wilwood????

Im not afraid o the superstrut by any means I just dont see where I would really benefit much from spending way more on an honestly problematic suspension system. I am using the GT4 calipers as I already have spent a good bit on rebuilding the calipers and buying a really nice set of EBC redstuff pads and rotors.

[dspain7]

Gran trabajo te va quedar nuevo, usas pintura en spray o es pistola?

Su pintura en aerosol pero una muy buena pintura en aerosol. Lo obtuve de Eastwood se llama "eastwood 2k underhood black".

[xgoma]

Amazing work, it looks really nice, you'll build a great car. I have the same project in mind, a swap to 3sgte with AWD conversion too, also coming from a 7afe stock. If everything goes well in about 3 months I'll start with it, so hope to continue reading this thread and watching the progression, and getting some ideas for my project. Good luck with the build and sorry if my english isn't perfect lol

[dspain7]

Amazing work, it looks really nice, you'll build a great car. I have the same project in mind, a swap to 3sgte with AWD conversion too, also coming from a 7afe stock. If everything goes well in about 3 months I'll start with it, so hope to continue reading this thread and watching the progression, and getting some ideas for my project. Good luck with the build and sorry if my english isn't perfect lol

Thanks man Im really putting a lot of time into it so it will turn out clean. Im hoping to start on the actual conversion this week. Things have been a little busy with work but I should have some time this week to get it at least stripped and started. Good luck with your build and I hope my thread will help you learn from my inevitable mistakes.

[dspain7]

Welp its sadly looking as though I will not get to work on the build any this week hopefully I will get some time this weekend.

[cheela]

take your time man. don't rush it. you're moving along pretty fast already.