6G Celicas Forums

Welcome Guest ( Log In | Register )

 
Reply to this topicStart new topic
> overheating? completely STUMPED
post Apr 4, 2010 - 7:00 PM
+Quote Post
mjoslin1990

Enthusiast

Joined Apr 4, '10
From Florida
Currently Offline

Reputation: 0 (0%)




I've replaced the rad, the t-stat, and upper rad hose. I'm car is driveable for about 10-15 miles then it starts to get hot (I pull over immediately).

The water pump is working, and so is my fan. My coolant is actually going back into the overflow tank and NOT cycling back into the radiator (SOMETIMES when its completely cooled is goes back, but not always)

I understand the most common issue is something as simple as the cap. I actually REPLACED the cap and it STILL was overheating (I'm thinking its a bad cap because the FIRST t-stat I bought WAS defective).

Say when I get my new cap (I put my old back on the new one is even worse, doesn't seal, and its the right one) I still overheat.

What could possibly be the next thing to look at? Mind you water pump DOES WORK, NO LEAKS, and its NOT the heads (did a pressure test and others).

Ideas????
__________________
~Miann
post Apr 4, 2010 - 9:31 PM
+Quote Post
soulshadow



Enthusiast
*****
Joined Apr 18, '05
From Lincoln, Ar
Currently Offline

Reputation: 7 (100%)




You've done a flush lately?
post Apr 4, 2010 - 9:57 PM
+Quote Post
mjoslin1990

Enthusiast

Joined Apr 4, '10
From Florida
Currently Offline

Reputation: 0 (0%)




yes I have
post Apr 4, 2010 - 11:53 PM
+Quote Post
Bitter

Enthusiast
*****
Joined Mar 11, '06
From Way South Chicago
Currently Offline

Reputation: 0 (0%)




what was wrong prior to replacing things? whats the history on this? were you low on coolant before and it was over heating or did it just suddenly start overheating and everything was in perfect working order? have you confirmed that its actually overheating and not just a faulty temp sender?


--------------------
post Apr 5, 2010 - 12:14 AM
+Quote Post
808celica



Enthusiast
*****
Joined Feb 24, '07
From Oahu, Hawaii
Currently Offline

Reputation: 23 (100%)




explain how you did your flush.

your channels could be clogged??? or the temp sensor

then use the stickies to find the CEL post to check if your temp sensor is bad


--------------------
I don't normally drive fast, but when I do its on a curvy section of this island
post Apr 6, 2010 - 9:01 AM
+Quote Post
soulshadow



Enthusiast
*****
Joined Apr 18, '05
From Lincoln, Ar
Currently Offline

Reputation: 7 (100%)




I'm Thinking you water pump is out. Its just free spinning and the blades are actually not rotating. Until you take it off and verify that it is working, its most likely your water pump atm. Remember to fill with 50/50 or mix 100% with distilled water. Don't be cheap and fill with sink water.
post Apr 6, 2010 - 12:40 PM
+Quote Post
nics



Enthusiast
*****
Joined Feb 15, '08
From Royal Oak, MI
Currently Offline

Reputation: 7 (100%)




what other test did you use for the internal leak other than the pressure test?

have you used this?
http://www.arrowheadradiator.com/head_gask...n_leak_test.htm


--------------------
God made man....
Everything else...
Made in China

post Apr 6, 2010 - 12:53 PM
+Quote Post
GriffGirl



Enthusiast
*****
Joined Feb 7, '07
From Portland, Oregon
Currently Offline

Reputation: 67 (96%)




You flushed it recently? I bet you've just got air in the system. Run your car for a few minutes with the radiator cap off, you need to burp the system. Air in the system will cause it to overheat. Don't forget to shut it off before you replace the cap though, just for safety purposes.


--------------------
post Apr 10, 2010 - 5:19 PM
+Quote Post
longgone

Enthusiast

Joined Feb 5, '10
From ireland
Currently Offline

Reputation: 0 (0%)




QUOTE (nics @ Apr 6, 2010 - 1:40 PM) *
what other test did you use for the internal leak other than the pressure test?

have you used this?
http://www.arrowheadradiator.com/head_gask...n_leak_test.htm

Yeah bleed the air out of your system and if the problem is still there then do a sniff test
as it looks like it's a head gasket problem

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: November 30th, 2024 - 8:14 PM