6G Celicas Forums

Welcome Guest ( Log In | Register )

 
Reply to this topicStart new topic
> Will GT4 driveshafts fit a ST202 SS2?
post Jul 5, 2010 - 4:22 PM
+Quote Post
Dave_ss2

Enthusiast

Joined Dec 29, '09
From UK
Currently Offline

Reputation: 0 (0%)




Hi everyone. Heres the story, I got a knocking from the o/s of the celi on the way home from japshow yesturday and after taking the wheel off i find grease splattered all over the place. the culprit is the CV boot of the drifshaft on the gearbox side. Going from the tick, tick tick noises it was making i have come to the conlusion that the drifshaft has broken (after the playful driving on the way home from japshow) and split the boot. I looked on ebay for st202 o/s driveshafts but was unlucky but there are a few GT4 driveshafts on there so i was wondering if anyone knew if the GT4 driveshaft could be used in a 1994 ST202 SS2? Cheers
post Jul 5, 2010 - 4:57 PM
+Quote Post
SwissFerdi

Enthusiast
*****
Joined Jun 18, '09
From Orlando
Currently Offline

Reputation: 8 (100%)




Well, seeing as a GT-4 would assumedly run an E-153 (154?) and your SS-II runs a...S54? I'm going to say no.

This post has been edited by SwissFerdi: Jul 5, 2010 - 4:57 PM


--------------------
'97 ST \ Eibach \ KYB \ Kenwood \ Alpine \ Cusco \ OEM+ [sold 10/18]
'93 MX-5 LE
post Jul 5, 2010 - 4:59 PM
+Quote Post
JuMPiiN



Enthusiast
****
Joined Nov 10, '09
From Louisiana
Currently Offline

Reputation: 5 (100%)




Sounds like your CV boot is the only thing that broke, not the entire drive shaft, dont hold me to this but the same thing happened to me and all i had to do was replace the CV boot and grease and it was fine.

BTW you can get a OEM replacement at a local part store, i think its like 80$ non ABS and like 110 with ABS. I just replaced both of mine before my engine went to hell.

This post has been edited by JuMPiiN: Jul 5, 2010 - 5:00 PM
post Jul 6, 2010 - 1:08 AM
+Quote Post
Dave_ss2

Enthusiast

Joined Dec 29, '09
From UK
Currently Offline

Reputation: 0 (0%)




ah ok cheers. I know this may sound like a stupid question but how can you tell if it is abs or not? there is no light in the dash. I found a couple on ebay last nite, one guy offered me the whole driveshaft off his celi that hes breaking for £30! bargain
post Jul 7, 2010 - 7:09 PM
+Quote Post
stephen_lee



Enthusiast
*****
Joined Mar 22, '07
From Houston, TX
Currently Offline

Reputation: 4 (100%)




abs will worn on a car w/o abs, but not the other way around


--------------------
QUOTE
"And, as always, your friendship, help, and dedication to the advancement of Texas Celica dominance is GREATLY appreciated. Thanks bro." -DEATH

1994 GT: V6 swap, 5speed E53 W/ LSD, All Power, now RED
1995 ST: SOLD @273k miles, Auto, all power, CarPC, White
1994 ST: Totaled, 5spd, all power, Red RIP 07/09/09 @ 241,810
1994 Lexus LS400: This is my new DD
post Jul 8, 2010 - 1:21 PM
+Quote Post
SwissFerdi

Enthusiast
*****
Joined Jun 18, '09
From Orlando
Currently Offline

Reputation: 8 (100%)




Well, I'm not sure how to tell non-ABS axles apart from ABS units, but...ABS-equipped Celis will have a box-shaped unit to the left of the engine, next to the fender and a foot or so from the radiator. Pretty sure it has a bunch of wires sticking out, etc. I know this is vague, let me find a picture.


--------------------
'97 ST \ Eibach \ KYB \ Kenwood \ Alpine \ Cusco \ OEM+ [sold 10/18]
'93 MX-5 LE
post Jul 9, 2010 - 7:34 AM
+Quote Post
stephen_lee



Enthusiast
*****
Joined Mar 22, '07
From Houston, TX
Currently Offline

Reputation: 4 (100%)




abs axles have a toothed ring on the outsede cv joint


--------------------
QUOTE
"And, as always, your friendship, help, and dedication to the advancement of Texas Celica dominance is GREATLY appreciated. Thanks bro." -DEATH

1994 GT: V6 swap, 5speed E53 W/ LSD, All Power, now RED
1995 ST: SOLD @273k miles, Auto, all power, CarPC, White
1994 ST: Totaled, 5spd, all power, Red RIP 07/09/09 @ 241,810
1994 Lexus LS400: This is my new DD
post Jul 22, 2010 - 7:28 AM
+Quote Post
Dave_ss2

Enthusiast

Joined Dec 29, '09
From UK
Currently Offline

Reputation: 0 (0%)




thanks for your help. I have a new driveshaft now and i was wondering if there was a guide on how to remove the old one? is there any little bastard things that i could get stuck on?
post Jul 22, 2010 - 12:19 PM
+Quote Post
stephen_lee



Enthusiast
*****
Joined Mar 22, '07
From Houston, TX
Currently Offline

Reputation: 4 (100%)




HOW TO


--------------------
QUOTE
"And, as always, your friendship, help, and dedication to the advancement of Texas Celica dominance is GREATLY appreciated. Thanks bro." -DEATH

1994 GT: V6 swap, 5speed E53 W/ LSD, All Power, now RED
1995 ST: SOLD @273k miles, Auto, all power, CarPC, White
1994 ST: Totaled, 5spd, all power, Red RIP 07/09/09 @ 241,810
1994 Lexus LS400: This is my new DD

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: November 30th, 2024 - 10:47 AM