 Shaving Spoiler |
  |
 May 5, 2004 - 8:31 PM
|
 
|
|
Enthusiast  Joined Mar 31, '04 From Cincinnati, OH Currently Offline Reputation: 0 (0%)  |
Planning on shaving the spoiler, but before I do - has anyone found a way to get rid of the holes? I'm open to ideas! And no, I'm not using duct tape.
|
|
May 5, 2004 - 8:32 PM
|
|
|
Enthusiast Joined Sep 25, '03 From cranston RI Currently Offline Reputation: 0 (0%) |
bondo
--------------------  |
|
May 5, 2004 - 8:42 PM
|
|
||
|
Enthusiast Joined Mar 31, '04 From Cincinnati, OH Currently Offline Reputation: 0 (0%) |
Will it look okay? I don't want it to look like I should have a primered bodykit bolted on too! 
|
||
|
May 5, 2004 - 9:13 PM
|
|
|
Enthusiast Joined Sep 25, '03 From cranston RI Currently Offline Reputation: 0 (0%) |
slap some bondo on, then sand it down till its smooth.... no matter what you'll have to have the area painted over...
-------------------- |
|
May 5, 2004 - 9:19 PM
|
|
|
Enthusiast Joined Mar 31, '04 From Cincinnati, OH Currently Offline Reputation: 0 (0%) |
Aiight, thanks
|
|
May 7, 2004 - 12:00 AM
|
|
|
Enthusiast Joined Sep 6, '03 From hudson ,iowa Currently Offline Reputation: 1 (100%) |
what yah do if yah dont want to paint and barly anyone well notice is take some interior plugs the black ones that have a flat top and lots of little grippers and shove it in there it should work seen it done on a turbo si civic that i show with/ well next week offcouse take some paint and math it to best you can the plugs
This post has been edited by pxcr440: May 7, 2004 - 12:00 AM |
|
May 7, 2004 - 10:27 AM
|
|
 Enthusiast Joined Aug 30, '02 From Ohio Currently Offline Reputation: 0 (0%) |
won't bondo crank cause there isn't anything under it to hold it??
i had to have mine welded over, then bondo'ed smooth. i heard u can use clear exterior silicone. put a piece of tape over the hole, squirt some silicone inside from underneath, let dry, take tape off and bondo. -------------------- Jared Harwell
 |
|
May 8, 2004 - 3:45 PM
|
|
 Enthusiast Joined Oct 20, '02 From Covington, La Currently Offline Reputation: 0 (0%) |
use fiberglass cloth or mat and resin. Let it dry, sand w/ light sand paper, clean w/ laquer thinner then place very thin even coat of bondo over. let it dry sand down, and if needed do second very thin even coat and sand down until completely smooth and even. Then clean again w/ laquer thinner, spray primer. and after use primer sealant so rust won't get under paint.
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: December 12th, 2024 - 12:17 PM |