JDM side markers, measurements Options

[Cragspider]

Ok, you euro guys, I need the measurements for the side markers. Ive got a set that Im putting on my car and I need to know the dimensions so that I can get them in the right spot. I need the height from the ground to the bottom of them, the distance to the side of them and any thing else that you all can think of that would help.
Bryan

[Mynzeyes]

just toss em on there. . i just looked at a spot on the fender...then put one of the markers there...measured down from the hood line straight down to the middle of the marker, then, from the door line over to the middle...and that gave me where to put the marker on the other side. it's inevitable that the markers will end up off by a tiny bit, but no one will ever be able to tell.

also, measuring up from the ground wouldn't be good, cause your car doesn't sit at the same height others' would...some may be lower, some may be higher...that's just a word of caution. .

btw, where you been, i haven't seen you on here that much? or around town, you ever in franklin anymore? or you just stay in Murf for school and what not?

-John-

[ghostdog]

I've actually thought about this. find a good picture of a jdm celi and measure the exact height/width of the fenders. then measure your cars fenders and figure out the ratio. now you measure how far down/to the left the light is from the edge of fender in the pictures, apply the ratio voila. maybe a bit complicated but its good to be precise

[neophile]

Hi

Here are some measurements I got of my car - the image is a bit big (mods might wanna put up a 56k warning) but I did it in photoshop and didn't wanna lose clarity by downsizing it too much

[Cragspider]