 Installing Bodykits, How hard is it? |
  |
 Jul 5, 2005 - 1:34 PM
|
 
|
|
Enthusiast Joined Jul 1, '05 Currently Offline Reputation: 0 (0%)  |
Just curious as to how hard it is to install most body kits. Is it typically just straight bolt-on or do you need to do some fabrication as well? Thanks,
ss |
|
Jul 5, 2005 - 1:45 PM
|
|
 Enthusiast  Joined May 22, '03 From NOVA Currently Offline Reputation: 16 (100%) |
normally a little sanding and your good....
about a 3 outta 10 on the tough scale |
|
Jul 6, 2005 - 4:38 PM
|
|
 Enthusiast Joined Jan 30, '05 From Greencastle, PA Currently Offline Reputation: 9 (100%) |
Depends on the kit. Some bolt right up, and fit well, other are sloppy, dont fit right, etc.
Just to get it put on isn't hard... -------------------- If anyone needs interior stuff, etc, I'm parting whats left of my celi out. Just ask.
|
|
Jul 6, 2005 - 11:02 PM
|
|
 Enthusiast Joined Jan 10, '04 From Shoreline, WA Currently Offline Reputation: 4 (100%) |
well my kit is a pretty bad quality kit, (well it looks good on the outside, but as far as the intstall, its a no brainer, almost a direct fit, no moddification to the kit or my car to make it go on and stay , just had to put some screws in and some 3m tape I think that most anyone who has worked on car a bit could do it. just take your time and dont rush any aspect of it, also test it it before you use tape and be ready to take it off and re-do it if its not perfectly alligned.
--------------------  |
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: December 4th, 2024 - 7:59 PM |