Vaccum Issues with swap, diagrams i have are bogus. Options

[jcbass7]

So i have the engine about to drop, but now with the wiring almost out of the way i have some vacuum issues to figure out.. and the diagrams i have are completly useless.

I have three vacuum lines that i am unsure of right now. Two come out of the top of the intake manifold and proceed across the sticker that says toyota... well here is a pic instead:




and the other comes out on the passenger side of the intake manifold near the throttle body heres a pic:


and another pic



it is the one on the left of the two, (the one with the black spiral cover thing)

thanks in advance

Jesse

This post has been edited by jcbass7: Jun 28, 2006 - 9:30 AM

[lagos]

the 2 in your 1st pic go to your charcole canister, and/or egr (for USDM motors) . you really dont need them hooked up and can just put vac caps on them.

the other one goes to your map sensor, aka turbo pressure sensor.

[brianforster]

damn you art, i wanted to feel smart for once, i knew the answer too

[Supersprynt]

With the 2 lines the one closer to the center of the engine is the charcoal cannister.

[jcbass7]

ok, i'm going to hook up the charcoal canister and such for the chance i might pass emissions



is the map sensor mounted on the firewall? or under the intake manifold?

thanks guys

PS: the engine is a JDM 1993 all-trac

ohhhh yea in the second picture under where the intercoolel hooks in, there is a fitting hanging there made out of brass maybe or whatever, but i think its my throttle body warmer? well im not sure where to hook it its just dangling right now,

This post has been edited by jcbass7: Jun 28, 2006 - 3:46 PM

[phattyduck]

ok, i'm going to hook up the charcoal canister and such for the chance i might pass emissions

is the map sensor mounted on the firewall? or under the intake manifold?

thanks guys

PS: the engine is a JDM 1993 all-trac

ohhhh yea in the second picture under where the intercoolel hooks in, there is a fitting hanging there made out of brass maybe or whatever, but i think its my throttle body warmer? well im not sure where to hook it its just dangling right now,

Your charcoal canister probably only has one connection on it, so you might still need to just block off one of those connections. I'm not sure which one to block off though... I still haven't figured that one out for my swap.

The MAP sensor is mounted to the firewall. I keeps the sensor from vibrating along w/ the motor.

The fitting there looks like it is for your cold start injector... Don't try to start the motor without that hooked up, or fuel will spray EVERYWHERE!

-Charlie

[jcbass7]

not sure if its the cold start injector or not, but i still can't locate the place to mount that end of it, ill keep searching...

[jcbass7]

not sure if its the cold start injector or not, but i still can't locate the place to mount that end of it, ill keep searching...

found it. im an idiot. directly under the intake manifold, had to take the throttle body off to get to it, but its all set

thanks guys