 Exhaust Pattern, those with aftermarket exhausts- help needed |
  |
 Oct 30, 2006 - 8:08 PM
|
 
|
 Enthusiast  Joined Nov 22, '05 From New Zealand, Hamilton Currently Offline Reputation: 2 (100%)  |
Does anyone have a pattern for a 3" celica st205 exhaust piping?
I want to get some stainless steel tubing mandrel bent to fit on the end of a down pipe but the dude said itd be better for him if i had a pattern for them to bend the pipes to. Do all afternmarket exhausts follow the same path? Does the type of material do anything for performance or just interms of quality? Is there any difference between cruch and mandrel bending? Thanks in advance This post has been edited by beno: Oct 30, 2006 - 8:11 PM |
|
Oct 30, 2006 - 11:04 PM
|
|
|
Enthusiast Joined Dec 5, '05 From LA, CA Currently Offline Reputation: 1 (100%) |
Your best bet is to get a bunch of bends (U-bends) that are pre-bent and have the shop cut and weld them together. No place that has a jig for building an ST205 exhaust would another shop borrow it, and just going off somebody's random pipe would probably lead to problems.
Other than getting over the front crossmember, the exhaust run is very straight and easy (run it under the rear axle). -Charlie -------------------- 2003 Subaru WRX Wagon
1989 Camry Alltrac LE 3S-GTE - SV25/ST205 hybrid 1988 Camry Alltrac LE - BEAMS swap started |
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: December 2nd, 2024 - 9:54 AM |