Exhaust for a 3sgte swapped celica, Anyone tried this yet? Options

[toyotacrazy]

I was considering buying this bolt on exhaust. I called the company and they said it is a direct bolt on for a st205. Im not sure if it would bolt onto a st204 with a 3sgte or if there would be problems. Its a cheap price for a stainless steel exhaust. I was hoping someone had some insight before I drop $350 on this exhaust. thanks

ebay

[x_itchy_b_x]

try it and let us know i don't see why it wouldn't it might be slightly off because it runs along side the drive shaft on a st205 but on the st204 it shouldn't matter. :shrug:

[robdrummer]

just make a custom one or have someone weld it for u

[Fastbird]

I don't think that will fit anything but a ST205. If you compare it to the one Dr. Tweak had fabbed for us you'll see how it bends differently around the rear axle/a-arm unlike the one on our car:

[toyotacrazy]

I think it may fit. It seems that yours is bent more. But if you compair them side by side it seems they are routed in the same place. If nothing else I can use the flex and center pipe and have the muffler welded onto another section to make it fit. Its worth a shot! Ill let you know but itll be a few months. I gotta get the money together. Later

[phattyduck]

The ST205 is completely different from the ST204 from the gas tank to the back of the car.... You *will* have to modify it to get it to fit, and it would probably be cheaper to go fully custom.

-Charlie

[Negative]

Do not buy SSautocrap! The stuff is made from inferior [thin] metals and it will most likely break. Also they will not answer your calls or call you back. For that money you could have one made at a local muffler shop that is custom fitted to your car and your specs.