 clutch reassembly |
  |
 Feb 25, 2008 - 10:16 PM
|
 
|
|
Enthusiast  Joined Jul 15, '07 From High ridge MO Currently Offline Reputation: 0 (0%)  |
what could prevent the transaxle casing from closing to a quarter inch gap into the engine and stop. I've taken the housing off twice!! I also noticed that even though the clutch alignment tool was in all the way, it appears the center of the clutch is about an eighth to a quarter inch above center of the pressure plate center, is that possible while using the alignment tool?
|
|
Feb 25, 2008 - 10:21 PM
|
|
 Enthusiast Joined Aug 9, '06 From Ma Currently Offline Reputation: 1 (100%) |
Assuming your slave cylinder isn't hooked up, misaligned clutch disc or theres a problem with the alignment pins.
Even if you installed the disc in backwards [you shouldn't have been able to bolt the pressure plate to the flywheel in this case], the trans would still bolt up. The problem would come when you tried to install the slave cylinder. This post has been edited by alltracman78: Feb 25, 2008 - 10:22 PM --------------------  |
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: February 20th, 2025 - 11:54 AM |