6G Celicas Forums

Welcome Guest ( Log In | Register )

 
Reply to this topicStart new topic
> engine swap, need some help
post Jan 6, 2003 - 5:42 PM
+Quote Post
94gtcelica



Enthusiast
*
Joined Dec 14, '02
From USA, NC
Currently Offline

Reputation: 0 (0%)




i was wondering if this would fit in my car, i have 1994 celica GT, ST204 with the 5S-FE, would this fit in my car 3SGTE 2ND GEN w/ 2ND GEN HEAD / FORGED TURBO PISTONS W/ CORE EX.
how well would this fit in my car and what else does it require....heres the site where i found it at....http://www.toysport.com/ENGINE%20LIST%20MARCH%202002.htm

if this wont fit what will?
post Jan 6, 2003 - 7:03 PM
+Quote Post
celicakid84



Enthusiast
**
Joined Aug 29, '02
From New Jersey
Currently Offline

Reputation: 0 (0%)




Yes that engine will bolt up to your stock transmission and your engine mounts. Several people have done a 3sgte swap or are in the process of doing so on celica.net. You should check out that site. I would suggest getting a full clip instead of just the engine because it becomes a pain to source all the little parts you will need for the swap. Go to www.celica.net and check out the sticky post in the 6th gen forum you can also use the search feature since this post has been covered extensively there.
post Jan 6, 2003 - 8:21 PM
+Quote Post
94gtcelica



Enthusiast
*
Joined Dec 14, '02
From USA, NC
Currently Offline

Reputation: 0 (0%)




where do i get a full clip and how much???
post Jan 6, 2003 - 9:07 PM
+Quote Post
celica3sgte



Enthusiast
***
Joined Nov 12, '02
From Columbus, Ohio
Currently Offline

Reputation: 15 (100%)




I wouldnt' get it from toysport they are too expensive. Try Johnnie Morris(at JEMCO), or Mike Coury at www.topshelfracing.com
I suggest getting one that is already in the county so it doesn't take too long. Buy a front clip. $2500 or less
here's some info
www.topshelfracing.com/project/
www.geocities.com/zegoat2000/homepage.html
post Jan 7, 2003 - 3:19 PM
+Quote Post
94gtcelica



Enthusiast
*
Joined Dec 14, '02
From USA, NC
Currently Offline

Reputation: 0 (0%)




i need info on a GT swap not a ST
post Jan 7, 2003 - 3:49 PM
+Quote Post
boosted_K2



Enthusiast
*****
Joined Aug 30, '02
From Michigan
Currently Offline

Reputation: 0 (0%)




QUOTE (celicakid84 @ Jan 6 2003, 07:03 PM)
Yes that engine will bolt up to your stock transmission and your engine mounts. Several people have done a 3sgte swap or are in the process of doing so on celica.net. You should check out that site. I would suggest getting a full clip instead of just the engine because it becomes a pain to source all the little parts you will need for the swap. Go to www.celica.net and check out the sticky post in the 6th gen forum you can also use the search feature since this post has been covered extensively there.

actually with a GT you really dont need a full clip, you really just need the ECU and wiring harness, saves some cash... STs are the only ones who would truely benifit from the full clip.


--------------------
IPB Image
Believer, you'll leave her, in leaving them all
No but I don't buy it
Like anything you do, as anyone you are
Cause I'm...
Ten Speed, of God's Blood & Burial
post Jan 7, 2003 - 4:28 PM
+Quote Post
Guest_Matthew_*











the benefit of getting a full clip is you can get the AWd tranny and rear differential and have everything you need for your car to release the full potential of this engine
post Jan 9, 2003 - 12:52 PM
+Quote Post
NiTTo

Enthusiast
*
Joined Dec 25, '02
From The Netherlands
Currently Offline

Reputation: 0 (0%)




1GGZE 2000CC 6 CYLINDER 24 VALVE SUPERCHARGED UNDER 10K $ 1,950.00
^question: how much horsies and torque does this sucker make and will it fit in a 6th gen?
post Jan 9, 2003 - 2:09 PM
+Quote Post
Guest_Matthew_*











it's a 2 liter 6 cylinder? I think that it either a 2 liter 4 banger or a 6 cylinder 3 liter. If you are referring to the engine that is found is the 7th gen celica. I don't think that it will fit. And for power I think that it is around 160 or so. But don't quote me on this I am just guessing.
post Jan 14, 2003 - 2:30 AM
+Quote Post
NEVERSTOP

Enthusiast
*****
Joined Nov 4, '02
From Davenport Iowa
Currently Offline

Reputation: 0 (0%)




QUOTE
actually with a GT you really dont need a full clip, you really just need the ECU and wiring harness, saves some cash... STs are the only ones who would truely benifit from the full clip.


This isn't entirely true... granted you pretty much do need a full clip for an ST swap and you can get buy without it on the GT...I did. but the clip would of been so much nicer to have... wouldn't need to relocate stuff.


--------------------

99 project version 3.0.. hello SEMA 2010 =)
post Jan 17, 2003 - 9:01 AM
+Quote Post
JiGGa

Enthusiast
*
Joined Dec 20, '02
From New York
Currently Offline

Reputation: 0 (0%)




I have a auto 1995 GT. Can I still put in a 3sgte? I want third generation and I want AWD on it if possible. Is that possible?

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: February 20th, 2025 - 5:41 AM