Installation Guide for Cold Air Intake, for 3rd or 4th Gen 3SGTE Options

[Dr_Tweak]

The Phoenix Tuning CAI for the 3rd and 4th gen 3SGTE swap into the 6th gen Celica is now available. The cost is $259 shipped to anywhere in the US:





The CAI kit includes:

Tig-welded, polished aluminum piping
AEM Dryflow Filter
Stainless-steel T-bolt clamps
4-ply Reducer/Coupling to connect to turbo
Bracket and hardware
Air hose fittings for PCV and IACV (optional, not pictured)

Installation

1. Remove your existing air intake.

2. Put both clamps into place and then connect the intake to the turbo.

3. Bolt the bracket to the frame rail as shown here:



4. Tighten the two t-bolt clamps at the turbo connection.

5. Install the filter and tighten the t-bolt clamp.

6. Insert the IAT sensor, and connect the air lines for the PCV and IACV (if used).

Any questions, post them up at http://www.phoenixtuning.com/forum/viewtop...123&start=0 or email me at drtweak@phoenixtuning.com

-Doc

[Batman722]

I didn't want to post up on your forum just yet. My problem with that is...

boo, that bolts to and is right were the stock st205 IC pump is.
Is there a nipple on it for the 205 oil catch can line ? (like the stock hose has)

also, what size piping is it ?

[Dr_Tweak]

I didn't want to post up on your forum just yet. My problem with that is...

boo, that bolts to and is right were the stock st205 IC pump is.
Is there a nipple on it for the 205 oil catch can line ? (like the stock hose has)

also, what size piping is it ?

I didn't know that about the ST205 IC pump. Bummerz

I guess one would just have to buy the intercooler kit too

Air hose fittings for PCV and IACV (optional, not pictured)

It is 3" piping.

-Doc