removin a cv joint/cv axle Options

[carcamo]

i need help on removin my driver ide cv joint on my 5sfe i dont seem to be able to pull it out of the tranny...is something else holdig it in? plz help me asap

[Spider77]

slide hammer with puller attachment.............telling ya it'll knock it out fast. Or just keep on pryin....just be carefuly not to damage the axle seal.

[Smaay]

there is a snap ring on the axle, you have to use a pry bar and pry one the axle. give it a small rotation then pry, repeate, it will pop out when it finds its sweet spot

[96stgreendemon]

while your replacing the cv go ahead and spend another 10 bucks on a new inner axle seal, and a seal puller, make sure you use the seal puller it will make your life a whole lot easier. and like i figured out its alot easier to replace it the first time than to take it apart and do it all again

[carcamo]

thanks to all of yall

[vile_v]

hope this helps!

http://www.6gc.net/forums/index.php?showto...2;cv+axle\

I would just get underneath the car, get a smackable large flat head screwdriver and smack that axle out.