Question about e153 Options

[cibrit-]

I currently have a 91 e153 (non-lsd) transmission in my car along with the 3sgte swap.

My question is: If I wanted to get a LSD transmission, would I have to change any parts off the non-lsd transmission swap? Or will all the parts that were required to get the non-lsd transmission to work, work with the LSD transmission?


The person that is selling the transmission is selling all of this as a package [$1600, without negotiating]

e153 LSD JDM transmission (~50 000 miles)
Set of e153 LSD Axles
Set of Alltrac Axles (new)
Alltrac shifter cables
Alltrac Front back crossmember and mounts
Alltrac drivers side engine mount
Alltrac shifter linkage assembly
Alltrac shifter fork and clutch slave cylinder with lines


I do know that I will need the axles, but would I need anything else?

Thanks,
Toni

[stephen_lee]

nope. the cases are the same. only difference should be the axles

UNLESS the trannt came from a MR2, then you will have to convert it to FWD.
then you will need your old hift selector and, shift cable bracket IIRC

[Smaay]

just buy an aftermarket LSD, then you can use your axles. if you upgrade to a 93+ then you need the axles too. and like said above, if its from an MR2 then you need to convert the shifter assembly to the backside of the tranny. you dont have to convert to FWD.