Installing Fuel Pressure Gauge Options

[Island_Racer]

Hey guys,
Ive installed one of thos aem fuel pressure gauges on my dash and have it wired up, only thing is, I wonder where to tap the pressure sensor.
Any tips on where anyone put theirs? I can make a part (like a "T" bracket) to put it anywhere pretty much, just wondering where is easiest so i can focus (by the regulator or by the entrance to the rail....or wherever else...)

thanks.

This post has been edited by Island_Racer: Jan 9, 2013 - 11:52 AM

[Smaay]

you want the sensor in the rail before the regulator. you will have to play around with fittings to get something that works.

[Smaay]

this is the banjo bolt that feeds the rail. if you can find a fitting that supports this banjo and also has an 1/8 NPT (your pressure sensor) then you should be good to go.



This post has been edited by Smaay: Jan 9, 2013 - 1:28 PM

[Island_Racer]

so basically this....

http://www.ebay.com/itm/Russell-640700-Fue...bc2&vxp=mtr

do you know the size banjo bolt (12X1.25??), so i can pull and replace same time?

thanks man

This post has been edited by Island_Racer: Jan 10, 2013 - 9:40 AM

[Smaay]

its either 10 or 12

[delusionz]

12x1.25

may aswell get a fuel regulator too while your at it, will have the port for the gauge/sender