Alarm/Remote Start Identification, There's one cut wire. No idea where it goes! Options

[Malek]

Pulled my carpet out today and found the original key fob so I changed the battery and reprogrammed it.

Weird thing is it communicates with the alarm ecu but it doesn't do anything after that i.e. lock/unlock, arm/disarm alarm. Key to ON, green button for three seconds, LED turns on, when I push the remote button it flicks the exterior lights once and turns the alarm LED off, key to OFF…and then my remote doesn't do a damn thing after that. Edit: I can get it in panic mode if I hold down the button. It's a start

So I did some digging, and found a 14 pin connector in the driver side footwell that was spliced into a ton of of factory wires. I searched the PN# and found that a guy on a mustang forum was having issues and he had the same connector. Mustang breh

PN# H04 AXE01B

Does anybody know what alarm/remote start/Godless SOB unit hooks up to this connector? Obviously, the previous owner had to bypass the factory RS3000 alarm but I don't know what he did to bypass it nor do I really want to dig into it. I'd much rather get whatever unit he had and be done with it. I just want my doors to unlock/lock from a key fob

Thanks for any and all help!

Edit: I can put the car in Panic mode

Here's the one cut wire. The grey one. The purple, brown, and other grey wire go to the security LED.





This post has been edited by Malek: Apr 26, 2013 - 9:35 PM