Beams (AT) Transmission Mount Options

[mr2perv]

If it's in this site somewhere< I missed it. Installed a 98 JDM Beams Super strut into a 98 GT Celica. Engine came with tranny and super strut already attached, so in it went. All good until I get to the L/H upper transmission mount. The US GT engine mount does not line up with the rear stud on the JDM tranny bracket and completely misses a hole on the engine side. (The US bracket won't mount to the tranny) By the way, this is an automatic (hold your comments), Russian site says it is an A140E. Modified the GT mount as much as I could, still pulling the other mounts about a half inch to the drivers side. The only mount that even comes close by the looks of it is the 96-00 Rav4 3sge mount, which is 200 bucks by itself, from Aussy site (which would be fine if I new that was correct). Anybody ever run in to this?