FS: 3S-GTE Motors, two motors 2nd and 3rd gen Options

[qatar11]

2nd Gen 3SGTE - complete (probably missing EFI reistor pack - most due). includes MAP, MAF, Turbo, Trans, Complete harness, Igniter, Coil, etc etc,

Asking $1300 plus shipping

3rd Gen 3SGTE - Motor, IC, Turbo, complete harness, ECU, Trans.. and thats about it... missing MAP, Coil, and Ingiter for sure, most likely missing important parts of the w/a intercooler system as well. best bet is FMIC

Asking $2000 plus shipping

Both motors have approx 40,000 miles on them.

Shipping will be around $400 range to contiential US

This post has been edited by Coomer: Feb 26, 2004 - 6:14 PM

[Jabberwock]

how many miles do the engines have?

[qatar11]

40,000 ish

[R-03]

for all you guys out there thinking about a swap, this is a good deal. i've put around $2,500 into my swap and didn't come with all this stuff qatar11 is including. by the way mike, harness is on the way.

[DG_Performance]

i am very interested in the 2nd gen setup you got!
i have been looking for a while for a good setup
has this setup been compression tested and leak down?
how much would you do my wireing for if i bought this from you?
i guess i would need to know shipping to zip 15419 too
i am deffinetly going to buy a 3sgte really soon , would like to keep the $ in the 6gc community if possible so i hop ewe can make a deal.
can i email you a few q's
dg

[boosted_K2]

mike, is the 3rd gen a MR2 3rd gen or a celica 3rd gen?

[qatar11]

the 3rd gen 3SGTE is from a celica, however it is missing most of the W/A intercooler goodies

[Stipt]

I got a TMIC if ya wanna buy that LoL!

[FallenHero]

I would pass a stone for that third gen engine.

So, let me get this straight: If I bought the engine, I would need a FF transmission and the wiring done (by you) plus piping and such for the FMIC i would need, and a way to bolt up a down pipe. That gives me a running 3s, correct?

[boosted_K2]

[qatar11]

DG -

my email address is mike@topshelfracing.com feel free to email me or AIM is qatar11

Wiring prices are $400 for ST185 -> 6th gen celica.

And yes the 3rd gen motor is missing a lot of essential pieces... but my importer had it on his list so i wanted to post it... the W/A intercooler will not work becuase it is most likely missing the W/A ECU, the water pump, the heat exchanger, etc..

[rlan214]

can't believe this all this goodies 5 miles from me and i can't afford it

[qatar11]

[qatar11]

ttt

[FallenHero]

So, if I bought the 2nd gen engine, I would need a transmission and the wiring. Am I right there? I don't suppose it would include the motor mounts would it? I wonder if an automatic 5s transmission would be suitable. (I have an auto right now and the manual swap would be .... painful)

[qatar11]

5SFE Automatic transmissions are not compatible with a 3SGTE engine. you would need trans, mounts, shifter linkage, powersteering stuff, drive axles.. and a few other things.

[capin_crunch]

Have you sold the engine yet? I am very interested in the 2nd gen 3sgte. How much would shipping be to 76015. Personal message me if you have any questions.

[qatar11]

ttt....

[qatar11]

For all you guys who wanted photos..

[Stipt]

A manual swap isn't all that painful, I'm going to write a "How To" on it when I get mine done in a couple weeks. The prices for the 3sge tranny runs between 250-400 depending who you go with. As for the other parts such as cables, cylinders, pedals etc... it should run you around another $200-$300. Save your pennies!

Edit: Work if you have someone to help ya that knows about cars, it should only take a few hours to do it, like I said, I'm going to write a "How To..." for the archieve to help those that want a MT but only have a AT. Wish me luck! LoL!

This post has been edited by Stipt: Mar 3, 2004 - 4:26 PM